How to Install Downspout Drain Lines (Buried Pipe, Emitters and Dry Wells)
Downspout extensions work, right up until someone mows over them, trips on them or kicks them aside for a party and forgets to put them back. A buried drain line does the same job permanently: the downspout drops into a pipe, the pipe runs underground with a steady fall, and the water comes up harmlessly in the lawn, or soaks into a dry well, well away from the foundation.
A buried downspout drain carries roof water at least 10 feet from the foundation through solid pipe (This Old House uses 4-inch PVC) laid with a fall of at least ¼ inch per foot, ending at a pop-up emitter, a dry well or another approved discharge point (This Old House; This Old House). Contact 811 a few business days before digging (811).
Before you start
- Check local rules. Some towns regulate where roof water can be discharged (onto neighbors, into storm sewers, onto sidewalks). Check before you choose an outlet (This Old House).
- Contact 811. It’s the free national before-you-dig service. Contact it, or your state’s 811 center website, a few business days before you dig; utilities will mark their buried lines with paint or flags (811; 811).
- Pick the outlet location: at least 10 feet from the foundation, downhill, and at least 3 feet from any property line for a dry well (This Old House). Don’t send water onto a walk or driveway where it can freeze (This Old House).
Materials
- Pipe: This Old House’s projects use 4-inch solid PVC for the run (This Old House). Smooth-walled pipe is generally easier to snake clean than ribbed corrugated pipe if it ever clogs.
- Downspout adapter (rectangular downspout to round pipe) and elbows.
- Outlet: a pop-up emitter, a dry well, or perforated pipe wrapped in landscape fabric to spread water into a bed (This Old House).
- Gravel, landscape fabric (for dry wells and perforated sections), a level, a shovel or trencher.
Step by step
- Lay out the route with stakes and string from the downspout to the outlet, as straight as possible, with as few bends as you can manage.
- Dig the trench. This Old House’s dry-well project digs trenches 6 to 8 inches deep (This Old House). In cold climates, talk to a local installer about depth and freezing.
- Set the slope. The pipe needs a steady fall of at least ¼ inch per foot toward the outlet (This Old House; This Old House). Check each length with a level as you go. A dip anywhere becomes a place where water and debris sit.
- Connect at the downspout with an elbow and adapter (This Old House).
- Install the outlet (see below).
- Test with a hose before backfilling: water should flow freely out of the far end.
- Backfill and reseed.
Pop-up emitter or dry well?
| Pop-up emitter | Dry well | |
|---|---|---|
| How it works | Lid pops up when water arrives and releases it onto the lawn | Buried chamber in gravel that lets water soak into the soil |
| Best for | Lawns that slope away from the house | Flat lots or where surface discharge isn’t allowed |
| Needs | Downhill outlet point | Soil that drains; space at least 10 ft from foundation and 3 ft from property lines (This Old House) |
| Effort | Low | High: This Old House rates it 5 of 5 for skill, 6–8 hours and about $200–$250 in materials (This Old House) |
| Maintenance | Keep the lid clear of grass and soil | Clean through the hatch or pop-up valve if it backs up (This Old House) |
This Old House’s dry-well method, in short: dig a hole about four feet deep and wide (roughly three times the size of the dry-well unit), line it with landscape fabric, add 4 to 6 inches of stone, set the dry well, backfill with stone around it, and cap it with a cover and a pop-up valve (This Old House).
Common mistakes
- Too little slope or a sag in the line, which collects silt until it clogs.
- No access for cleaning. Plan where you’d feed a snake in, and avoid sharp bends.
- Discharging too close, so water soaks back toward the foundation anyway.
- Skipping the hose test before backfilling.
- Dumping gutter debris into the line. Keep the gutters clean or guarded, or add a strainer at the downspout.
If an existing line stops draining, see how to unclog an underground downspout.
Compare installed prices near you
Free quotes from up to 3 local gutter guard installers. No obligation.
Sources
- This Old House, “How To Drain Downspout Water Flow Away From a House” (May 2026). thisoldhouse.com
- This Old House, “How to Install a Dry Well and Divert Rain Run-Off” (June 2026). thisoldhouse.com
- 811, “811 Before you dig” and “Information for Homeowners”. 811beforeyoudig.com