Gutter Splash Guards: Stop Valley Water Overshooting Your Gutters
Every house with a roof valley has one gutter corner that misbehaves. Two roof planes meet, the water from both runs down the valley as one fast stream, and at the bottom it hits the gutter with enough speed to leap right over the front, usually onto a walkway or into a flower bed that’s been washed out every spring.
A gutter splash guard is a small metal shield fixed to the outside edge of the gutter where heavy flow arrives, typically at an inside corner below a roof valley. It catches water that would overshoot and turns it back into the gutter (This Old House). It’s a 30-minute job with basic tools. It fixes overshoot at that spot only: if the whole run overflows, the problem is capacity or clogs, not splash.
Where splash guards go
- Inside corners below roof valleys, the classic spot.
- Under steep roof sections where water arrives fast.
- Anywhere you see water jumping the gutter while the rest of the run handles rain fine.
Watch the gutter in a heavy rain to find the exact spot where the stream lands, and fit the guard there rather than guessing from the valley line.
Types
Splash guards come as straight, curved or corner pieces (This Old House). Choose aluminum or stainless steel over PVC or vinyl for durability, and check fit: most products are made for K-style aluminum gutters (This Old House). They’re inexpensive; This Old House’s examples were packs of two or three for roughly $13 to $28 (This Old House).
How to install one
Tools: ladder, caulk gun with gutter sealant, screwdriver or drill, self-tapping screws. Check your gutter warranty first (This Old House).
- Clean the corner and dry it.
- Dry-fit the guard on the outside edge of the gutter where the water lands.
- Run a bead of sealant along the gutter where the guard will sit (This Old House).
- Set the guard and fasten it with self-tapping screws.
- Seal the edges again (This Old House).
- Test with a hose from the roof valley, or wait for the next storm.
If it still overshoots
A splash guard redirects water; it doesn’t add capacity. If water still escapes:
- Check the downspout. A splash guard won’t help a gutter that’s already full. This Old House’s rule of thumb is about 1 square inch of downspout opening per 100 square feet of roof; a 3×4-inch downspout handles about 1,200 square feet (This Old House).
- Clear the valley of debris, which can build up and send water over the guard.
- Add a downspout near the corner, or upsize the gutter. See overflowing gutters.
- If you have hood-style gutter guards, overshoot may be the guard, not the valley. See gutter guard problems.
Compare installed prices near you
Free quotes from up to 3 local gutter guard installers. No obligation.
Sources
- This Old House, “Gutter Splash Guards” (May 2026). thisoldhouse.com